DAP® OneStik2® and StikArounds® Glass Ornaments
Level = Beginner 
One ornament will take approximately 30 minutes to create and 24 hours to dry completely.
YOU WILL NEED:
INSTRUCTIONS:
For lines of ribbon: cut lengths of StikArounds® Continuous Lines the same length as the diameter of the ornament. Following the
StikArounds® box directions, firmly press the adhesive in a straight line around the ornament. Remove the liner, taking care not to touch
the adhesive as fingers may leave an oily residue on the adhesive. Cut the ribbon the same length as the adhesive and firmly press the
ribbon over the StikArounds® line.
To adhere glass beads or sequins: apply a dot of One Stik2® adhesive using the fine-point end of the pen, being sure to following directions on the package. Firmly press sequins into adhesive and allow to dry. To apply glass beads, use pin-point tweezers to press the bead into the adhesive and allow to dry.
To apply glitter in a "polka dot" pattern: following directions on the pack of the box, apply StikArounds® Adhesive Spots onto ornament, taking care not to touch the adhesive spots as fingers may leave oily residue on the adhesive. On the sketch paper, pour out a quarter-sized amount of glitter and then firmly roll the area of the ornament with the StikArounds® in the glitter.
To apply glitter in a shaped area: use either end of the One Stik2® pen to apply adhesive. With fingers, sprinkle glitter over wet adhesive and then gently press glitter into adhesive with fingers.
Cut ribbon to desired length to create decorative ornament hook.
Allow One Stik2® to dry completely.
For the store closest to you with these DAP products, visit DAP's "Where to Buy" feature on www.dap.com.
|